NBITS/de

= (**COPIED FROM ENGLISH PAGE**) === Action

Set all except the specified bits to 1.

 

 

Syntax

Var = NBITS( b1 [,bn])

 

 

Remarks

Var	The BYTE/PORT variable that is assigned with the constant.
B1 , bn	A list of bit numbers that NOT must be set to 1.

 

While it is simple to assign a value to a byte, and there is special Boolean notation &B for assigning bits, the Bits() and NBits() function makes it simple to assign a few bits.

 

B = &B01111101 : how many zero’s are there?

This would make it more readable: B = NBits(1, 7)

You can read from the code that bit 1 and bit 7 are NOT set to 1.

It does not save code space as the effect is the same.

 

The NBITS() function will set all bits to 1 except for the specified bits.

It can only be used on bytes and port registers.

Valid bits are in range from 0 to 7.

 

 

See Also

BITS

 

 

Example

'--------------------------------------------------------------------------------
'name : bits-nbits.bas
'copyright : (c) 1995-2005, MCS Electronics
'purpose : demo for Bits() AND Nbits()
'micro : Mega48
'suited for demo : yes
'commercial addon needed : no
'use in simulator : possible
'--------------------------------------------------------------------------------
 
$regfile = "m48def.dat" ' specify the used micro
$crystal = 4000000 ' used crystal frequency
$baud = 19200 ' use baud rate
$hwstack = 32 ' default use 32 for the hardware stack
$swstack = 10 ' default use 10 for the SW stack
$framesize = 40 ' default use 40 for the frame space
 
Dim B As Byte
 
'while you can use &B notation for setting bits, like B = &B1000_0111
'there is also an alternative by specifying the bits to set
B = Bits(0 , 1 , 2 , 7) 'set only bit 0,1,2 and 7
Print B
 
'and while bits() will set all bits specified to 1, there is also Nbits()
'the N is for NOT. Nbits(1,2) means, set all bits except 1 and 2
B = Nbits(7) 'do not set bit 7
Print B
End

Languages	English • Deutsch