Admin: 1 revision

2013-02-15T19:14:19Z

1 revision

Admin at 20:13, 8 February 2013

2013-02-08T20:13:02Z

New page

== (**COPIED FROM ENGLISH PAGE**) === Action =

Configures the direct memory access (DMA) module of the XMEGA.

 

 

= Syntax =

CONFIG DMA=enabled|disabled, DOUBLEBUF=db, CPM=cpm

 

 

= Remarks =

 
<div style="padding: 0px; margin: 0px 0px 0px 4px;">
{| width="604" cellspacing="0" cellpadding="1" border="1" style="border: 2px solid rgb(0, 0, 0); border-spacing: 0px; border-collapse: collapse;"
|- style="vertical-align: top;"
| valign="top" width="16%" style="width: 93px; border: 1px solid rgb(0, 0, 0);" |
DMA

| valign="top" width="100%" style="width: 502px; border: 1px solid rgb(0, 0, 0);" |
By default the DMA is disabled. Use ENABLED to enable the module.

|- style="vertical-align: top;"
| valign="top" width="16%" style="width: 93px; border: 1px solid rgb(0, 0, 0);" |
db

| valign="top" width="100%" style="width: 502px; border: 1px solid rgb(0, 0, 0);" |
DOUBLE BUFFER

This options will set the double buffer mode. By default is is DISABLED.

To allow for continuous transfer, two channels can be interlinked so that the second takes over the transfer when the first is finished and vice versa. This is called double buffering. When a transmission is completed for the first channel, the second channel is enabled. When a request is detected on the second channel, the transfer starts and when this is completed the first channel is enabled again

 

Modes :

- DISABLED : No double buffer enabled

- CH01 : Double buffer enabled on channel0/1

- CH23 : Double buffer enabled on channel2/3

- CH01CH23 : Double buffer enabled on channel0/1 and channel2/3

|- style="vertical-align: top;"
| valign="top" width="16%" style="width: 93px; border: 1px solid rgb(0, 0, 0);" |
cpm

| valign="top" width="100%" style="width: 502px; border: 1px solid rgb(0, 0, 0);" |
Channel Priority Mode

If several channels request data transfer at the same time a priority scheme is available to determine which channel is allowed to transfer data. Application software can decide whether one or more channels should have a fixed priority or if a round robin scheme should be used. A round robin scheme means that the channel that last transferred data will have the lowest priority

 

Modes :

RR : Round Robin

CH0RR123 :  Channel0 > Round Robin (Channel 1, 2 and 3)

CH01RR23 : Channel0 > Channel1 > Round Robin (Channel 2 and 3)

CH0123 : Channel0 > Channel1 > Channel2 > Channel3

 

|}
</div>
 

You also need to set the individual DMA channels using CONFIG DMACHx.

 

= See also =

[[CONFIG_DMACHX|CONFIG DMACHx]] , [[START_DMACHX|START DMACHx]]

 

 

= Example =

See [[CONFIG DMACHX|CONFIG DMACHx]] {{Languages}}

[[Category:BASCOM Language Reference/de]]

CONFIG DMA/de - Revision history

Admin: 1 revision

Admin at 20:13, 8 February 2013