CONFIG X10

Action

Configures the pins used for X10.

 

 

Syntax

CONFIG X10 = pinZC , TX = portpin

 

 

Remarks

PinZC	The pin that is connected to the zero cross output of the TW-523. This is a pin that will be used as INPUT.
Portpin	The pin that is connected to the TX pin of the TW-523.   TX is used to send X10 data to the TW-523. This pin will be used in output mode.

 

 

The TW-523 RJ-11 connector has the following pinout:

Pin	Description	Connect to micro
1	Zero Cross	Input pin. Add 5.1K pull up.
2	GND	GND
3	RX	Not used.
4	TX	Output pin. Add 1K pull up.

 

 

See also

X10DETECT , X10SEND

 

 

Example

'-----------------------------------------------------------------------------------------
'name : x10.bas
'copyright : (c) 1995-2005, MCS Electronics
'purpose : example needs a TW-523 X10 interface
'micro : Mega48
'suited for demo : yes
'commercial addon needed : no
'-----------------------------------------------------------------------------------------
 
$regfile = "m48def.dat" ' specify the used micro
$crystal = 8000000 ' used crystal frequency
$baud = 19200 ' use baud rate
$hwstack = 32 ' default use 32 for the hardware stack
$swstack = 10 ' default use 10 for the SW stack
$framesize = 40 ' default use 40 for the frame space
 
 
'define the house code
Const House = "M" ' use code A-P
 
Waitms 500 ' optional delay not really needed
 
'dim the used variables
Dim X As Byte
 
'configure the zero cross pin and TX pin
Config X10 = Pind.4 , Tx = Portb.0
' ^--zero cross
' ^--- transmission pin
 
'detect the TW-523
X = X10detect()
Print X ' 0 means error, 1 means 50 Hz, 2 means 60 Hz
 
Do
Input "Send (1-32) " , X
'enter a key code from 1-31
'1-16 to address a unit
'17 all units off
'18 all lights on
'19 ON
'20 OFF
'21 DIM
'22 BRIGHT
'23 All lights off
'24 extended code
'25 hail request
'26 hail acknowledge
'27 preset dim
'28 preset dim
'29 extended data analog
'30 status on
'31 status off
'32 status request
 
X10send House , X ' send the code
Loop
 
Dim Ar(4) As Byte
X10send House , X , Ar(1) , 4 ' send 4 additional bytes
End

Languages	English • Deutsch